Laguna Tools Fusion F1 Owner's Manual

Also see for Fusion F1: Owner's manual

Laguna Tools Fusion F1 Owner's Manual Manual pdf 28 page image

F1 Table Saw28Safety Device AlignmentFig T013: Safety Device adjustments. (1) locking bolts. (2) adjustment set screws.The riving knife, blade guard, or splitter must be aligned with the blade to be used effectively. The rivingknife should only be used with blades specified on the riving knife (or vice versa). To adjust the position ofthe blade safety attachments, relative to the saw blade:• Loosen the two locking bolts. These two bolts fasten the assembly in-between the set screws and thearbor block.• Adjust the set screws as needed to correct the out-of-align blade attachment. Do small adjustmentsand check.Table/Blade/Fence AlignmentFig T021: Blade/Table alignment with mitre gauge and dial indicator.It is good practice to make sure that the table is always parallel to the blade by checking it often. You cando this with a combination square or with a dial indicator on an appropriate mount. There are severaldedicated tools to do this job well like the saw gauge sold by WoodPecekers®.With the throat plate and all attachments removed, raise the blade to the highest position at 90 degrees withthe table. Take an initial measurement about ½ inch from the ground edge of the blade as shown.Keep the miter gauge against the left rail and slowly move across the blade. Take the second measurementand compare with the initial measurement. Adjust the table to compensate false measurements. There are3 bolts to loosen prior to adjusting the table.