Laguna Tools Fusion F1 Owner's Manual

Also see for Fusion F1: Owner's manual

Contents

Laguna Tools Fusion F1 Owner's Manual Manual pdf 13 page image

2. Setup13 2. SetupFusion F1 Tablesaw © 2018 Laguna Tools 7/31/2018EN2. SetupWARNING!WARNING! Never perform any setup, maintenance or adjustments with the machine connected to the powersource!WARNING! If you have any doubt about the described procedure, seek professional assistance. Do not attemptany procedure that you feel is unsafe, or that you do not have the physical capability of achieving.WARNING! When removing packaging banding, extreme caution must be used as the banding will spring whencut.CAUTION! The machine is heavy. Ensure that you have enough people to do the job safely.NOTE: There may be sawdust in or around your new machine as a result of thorough testing.NOTE: The indexing numbers used to describe images are not the same as those indexing numbers used todescribe the individual parts in the Parts Section exploded views. This is done solely to help with assembly andgive better instructions to those receiving the machine new. When ordering replacement parts, please onlyconsult the part numbers and reference images in the Parts Section.The machine comes as assembled as possible without impacting shipping costs.However, there will always be some setup procedures and adjustments that thecraftsman must perform prior to using the machine. Those setup sections thatmust be done to complete the assembly of the machine are in the General Setupsub-section. Those help topics for making operational changes to the machine inorder to set up for a different function are in the Functional Setup sub-section.If you are looking for adjustments, such as how to align the blade to the table,please navigate to the Maintenance Sections .2. Setup Contents2.1 Preparing For Setup2.2 Inventory2.3 General Setup2.4 Functional Setup2.1 Preparing For SetupFig T002: Receiving and unboxing the Fusion Tablesaw.ReceivingIt is likely that your machine will be delivered by a third party. Before unboxing, besure to inspect the packaging and shipping documents supplied by the driver.Ensure that there is no visible damage to the shipment. If any damage has occurredbecause of shipment, note the damage on the bill of lading or refuse the shipment.Immediately call the dealer store where the machine was purchased.1. Never accept a shipment that is damaged or partial without notifying theshipping company and the purchasing store.PlacementPrior to removing the machine from the packaging, decide the operating location ofthe machine. The dimensions and floor space can be found here: Dimensions .1. There should be sufficient area at the front of the machine to allow you to workon it comfortably.2. There should be sufficient area at the back of the machine to allow access foradjustments and maintenance to be conducted.3. The better the lighting the more accurately and safely you will be able to work.4. You should select a solid flat floor, preferably one made of concrete orsomething similar.5. Locate it close to a power source and dust collection (if applicable).UnboxingOnce in place, carefully unbox and remove all components. Unboxing guidelines:1. Do not cut deep into a box with a blade as it could scratch the paint; only cutdeep enough to cut the tape or use a dull edge.2. Prior to setting up the machine, organize all hardware and setup tools needed.151719131415179