Labgear LAB350T User Manual

Labgear LAB350T User Manual Manual pdf 1 page image

•Ideal for fringe reception areas•Tilting mast clamp for easy adjustment•Easy dipole assembly•Unique compact folding design•Frequency: 470 - 790MHz•Forward Gain: 13dBi•Length: 680mm•Electronic 75Ω balun•Connection: F typeCongratulations on the purchase of your high gain digital aerial. The aerial is ideal for thereception of all available signals in medium, weak and fringe areas.The aerial has also been designed to restrict bandwidth to prevent interference &channel loss on TVs caused by signals from 4G mobile phone transmitters.The aerial is of particularly robust construction to ensure a long operating life.For optimum results install the aerial using double screened CAI approved digital coax cableand screened coax outlets. You will need to fit the coax cable with an F type connector toconnect to the aerial balun.1. Prepare the Coax Cable: Firstly fit the rubber weather boot provided, to theaerial end of the cable. Strip the end of the cable as shown in Fig. 1.Once you have stripped the cable, twist the braid and pull it back on itself,make sure that no braid is touching the copper core, this will cause a shorton the cable and you will not get any signal.2. Fitting the F connector (not supplied): Now, simply twist on an‘F’ connector and trim central conductor.fold braid backover sheath8mminnerwirecut or tearaway foil6.5mmFig. 1screw connectorbody onto cable2mm approx.end ofinsulationshould beflush withthis faceFig. 2For best results the aerial should be mounted on an outdoor aerial mast andpointed in the direction of the nearest transmitter* making sure it is in a positionwhere the transmitter signal will not be obstructed by nearby trees and buildings.If you are in any doubt about the direction in which the aerial should be pointingor the orientation of the aerial (horizontal for main transmitter, vertical for relaytransmitter) check your neighbours’ aerials.3. Unfold the booms as shown above. To lock the booms in position turn both ofthe two knobs on either side of the aerial in a clockwise direction through 180˚making sure that the arrows line up with the locked symbol - see Fig. 4.4. Next fasten the balun to the underside of the main central boom as shown in Fig. 5.Make sure the balun is the right way round with the locating stud slotted into thelocating hole on the underneath of the central boom.Fig. 3Fig. 4Locking knobLockedSymbolInstallation InstructionsLte800READYHigh Gain Professional T Band AerialLAB350T USER GUIDEFig. 5locating stud

/ 2

Related manuals for Labgear LAB350T