POWER CORE User Manual Version: V6.0.0/5 129/4599. Audio Mix EngineIn State Can be assigned to the OutState of another TConn64, a Button16 or Button64 in order tocascade elements (see below).Or, to the Save Out state from a System Defintion -> Parameter = ElementState snapshotin order to respond to snapshot recalls.Pushout When checked, Pushout is active.Disable Inhibits the setting of another trigger.Reset This control signal resets the TConn64. It can be used to define a default connectionwhich is activated by the Reset control signal.If Pushout is active, and the Reset control signal is triggered then Audio In PO 1 and 2 areassigned to Audio Out 1 and 2.If Pushout is not active, and the Reset control signal is triggered then the Preset inputs(below) are assigned to Audio Out 1 and 2.Preset Enter the number of the audio input which you wish the TConn64 to reset to when Reset isactioned. This is also the state which the TConn64 will reset to after a cold start.The individual control outputs of the TConn64 appear under the “Logic -> -> TConn64” of the 'TreeSelection' window. In addition, you will find the element's Out State under “Element State -> GroupName ->TConn64”.Cascading TConn64 & Button 16/64 ElementsThe Global -> In State of a TConn64 can be assigned to the Out State of another TConn64, Button16 orButton64 in order to cascade elements. The Out State of the master element should be assigned to the In Stateof the slave. The slave will then follow all switch changes which occur in the master.
