KitchenAid KDTM384ESS User Instructions

Also see for KDTM384ESS: User instructions Technical education User guide

Contents

KitchenAid KDTM384ESS User Instructions Manual pdf 12 page image

12Dishwasher Feedback SectionCanceling a Cycle1. Open the door slightly to stop the cycle. Wait for the sprayingaction to stop before completely opening the door.2. Press and hold CANCEL/DRAIN button once. The Cancel/Drain light will light up.3. Close the door and the dishwasher starts a drain cycle (if waterremains in bottom of dishwasher). Let the dishwasher draincompletely. The Cancel/Drain light turns off after 2 minutes.Changing a Cycle After Dishwasher Is Started1. You can interrupt a cycle and restart your dishwasher from thebeginning using the following procedure.2. Open the door slightly to stop the cycle. Wait for the sprayingaction to stop, then open the door completely.3. Check that detergent dispenser cover is still closed. If cover isopen, you will need to refill the detergent dispenser beforerestarting your new cycle.4. Press CANCEL/DRAIN and wait approximately 2 minutes untilthe machine drains and the Cancel/Drain light turns off.5. Select new cycles and options.6. Press START/RESUME.Adding a Dish After Dishwasher Is StartedIf your dishwasher has an “Add Dish” indicator:1. Open the door slightly to stop the cycle. Wait for the sprayingaction to stop and then completely open the door.2. Add a dish to the load while the indicator is lit.3. Press the START/RESUME button and close the door. If thedoor is not closed before the countdown timer ends you willhear a series of beeps and the dishwasher will not start.If your dishwasher does not have “Add Dish” indicator:1. Open the door slightly to stop the cycle. Wait for the sprayingaction to stop and then completely open the door.2. If the detergent dispenser door is closed you may add a dish. Ifthe detergent dispenser door is already opened an added dishmight not be cleaned.3. Press the START/RESUME button and close the door. If thedoor is not closed before the countdown timer ends you willhear a series of beeps and the dishwasher will not start.To reset any cycleand options duringselection or to cancela wash cycle anddrain the dishwasherafter it has started.Press and hold CANCEL/DRAIN to reset any control selections made.See the “Canceling A Cycle After Dishwasher Is Started” and “Changing A Cycle AfterDishwasher Is Started” sections.To turn the audibletones on or off.Press and hold the HI TEMP WASH button for 3 seconds to turn the audible tones on oroff. Only audible tones for confirming button presses can be turned on/off. Importantaudible tones, such as indicating a cycle has been interrupted, cannot be deactivated.CONTROLS AND CYCLE STATUSCONTROL PURPOSE COMMENTSThe Cycle StatusIndicator Light isused to follow theprogress of thedishwasher cycle. Itis located on thefront of the door.The single indicator light on the front of the door panel (A) will remain blueduring wash/rinse, red during dry, and white when complete.The Cycle StatusDisplay is used tofollow the progressof the dishwashercycle, and to showother information.The Time Display is used for estimated cycle time and also for delay hours.Estimated cycle time is displayed in hours and minutes as you make cycle andoption selections. After you start the dishwasher, the display counts downthe time.After you press the Start/Resume button, the Time Display counts downseconds to close the door. If the door is not closed by the end of thecountdown you will hear a series of beeps and the cycle will not start.When you select the Delay feature, the Time Display will give the number ofhours followed by an “H”.CONTROLS AND CYCLE STATUSCONTROL PURPOSE COMMENTSA