King-Dome 9630 Installation And Operating Instructions Manual

Also see for 9630: Troubleshooting guide

Contents

King-Dome 9630 Installation And Operating Instructions Manual Manual pdf 13 page image

Page 11SECTION 4 OPERATION1. Turn TV and satellite receiver on.2. Go to the signal meter screen on TV.Choose transponder number: Dish Network #11DIRECTV #193. Enter local ZIP code on signal meter screen to determine satelliteelevation. If you do not know your local zip code, determine yourelevation from the maps on pages 12-14.4. Press and hold UP/ON arrow on King-Dome Controller for3 FULL SECONDS to turn King-Dome on.5. Press UP or DOWN arrow on King-Dome Controller to matchelevation on Controller to elevation on TV signal meter screen orelevation from maps on pages 12-14.6. Press and hold RIGHT arrow until Controller begins RAPIDLYflashing its clock position (7-10 seconds). (See Fig. 2, Page 3.)Remember, you must watch for signal strength on TV!Dish will automatically perform a 360 degree scan for satellite.When signal strength appears on TV, press ANY BUTTON to stopthe dish from rotating.7. Press the UP, DOWN, LEFT or RIGHT arrows to fine tune signalstrength to the highest possible number on TV signal meter screen.Enjoy your programming!IMPORTANT! There must be a clear “line of sight” to the southern sky. Mountains,buildings, trees, telephone poles, etc. can all block the satellite signalfrom reaching the dish.IMPORTANT! In Step 6, as soon as you begin holding the rightarrow, you must continuously monitor the TVsignal meter screen until signal appears on TV.Note: The Controller will flash a series of codes and then display itselevation. Wait for the Controller to steadily display theelevation before continuing (about 10 seconds).