MAVO LF Operation Manual(KineOS 6.2)©2019 Kinefinity Inc. Page 3 / 62SAFETY TIPSPlease read all contents of the manual carefully: Pay attention to the CAUTION and NOTE; Do not use the camera near water in case of water droplets that can splash on the camera body; Do not expose the camera to severe vibrations; Do not use camera under direct sunlight; operating temperature should be from 0 ℃ to 40℃; Do not use the camera near strong magnetic field, pretty dust, high humidity or lighting storm places; Avoid condensation during transportation or transitions; Do not block the vent, or it will cause overheating that will damage the camera; Do not expose the LCD/OLED screen to harsh direct sunlight, and do not squeeze or hit the monitor incase of any damage to the screen; Only use accessories recommended by Kinefinity.While using the camera, please: Turn off the camera when you try to attach or detach a Lens Mount, KineBACK-W or HDMI monitor; Avoid touching the OLPF when attaching or detaching an adapter, as the optical element is fragile.MAVO LF is with changeable OLPF, please be careful when you change it; The EF mounting adapter is a lever-locking (cine-type) EF mount. When mounting a lens to the camera,the position of red dot in the mount is DIFFERENT from a DSLR camera. Secondly, it is a LOCKING RINGrotation, NOT a lens rotation. Make sure the EF lens is aligned pogo-pin contact inside of EF mount,now you can firmly lock the lens in place by rotating the locking ring on the lens mount (the arrow onthe mount suggests which direction); Hold the lens while detaching it from the lens mount, to prevent from accident. We strongly recommend inserting or removing the SSD only after camera is powered down. If you liketo hotswap, you must Deactivate the SSD at first (SSD section in UI shows SSD: Ins), and then push upthe SSD latch to get the SSD out.