Kinco FV100-2S-0004G User Manual

Also see for FV100 Series: User manual User manual

Contents

Kinco FV100-2S-0004G User Manual Manual pdf 36 page image

3333Note:1 ． Please set Fmax, FH and FL carefully according tomotor parameters and operating states.2． FH and FL is invalid for JOG mode and auto tuningmode.3．Besides the upper limit of frequency and lower limitof frequency,the drive is limited by the setting value offrequency of starting,starting frequency of DC brakingand hopping frequency.4．The Max. output frequency,upper limit frequency andlower limit frequency is as shown in Fig.6-1.5．The upper/lower limit of frequency are used to limitthe actual output frequency.If the preset frequency ishigher than upper limit of frequency,then it will run inupper limit of frequency.If the preset frequency is lowerthan the lower limit of frequency,then it will run in lowerlimit of frequency.If the preset frequency is lower thanstarting frequency,then it will run in 0Hz.A0.13 Torque boost of motor 1 0.0～30.0％【0.0％】In order to compensate the torque drop at low frequency,the drive can boost the voltage so as to boost the torque.This function code is corresponding to maximum outputvoltage.If A0.13 is set to 0, auto torque boost is enabled and ifA0.13 is set non-zero, manual torque boost is enabled,as shown in Fig. 6-2.Vb:Manual torque boost Vmax: Max. output voltageFz:Cut-off frequency for torque boost Fb:Basic operating frequencyOutputvoltageFbVbVmaxOutput frequencyFzFig.6-2 Torque boost(shadow area is the boostedvalue)Note:1. Wrong parameter setting can cause overheat orover-current protection of the motor.2. Refer to b1.07 for definition of fz.6.2 Group A1A1.00 Starting mode 0、1、2【0】0.Start from the starting frequencyStart at the preset starting frequency (A1.01) within theholding time of starting frequency (A1.02).1.Brake first and then startBrake first(refer to A1.03 and A1.04), and then start inmode 0.2.Speed trackingNotes:Starting mode 1 is suitable for starting the motor that isrunning forward or reverse with small inertia load whenthe drive stops. For the motor with big inertial load, it isnot recommended to use starting mode 1.A1.01 Starting frequency0.00～60.00Hz【0.00Hz】A1.02 Holding time of startingFrequency 0.00～10.00s【0.00s】Starting frequency is the initial frequency when the drivestarts, as shown in Fig. 6-3 as FS; Holding time ofstarting frequency is the time during which the driveoperates at the starting frequency, as shown in Fig. 6-3as t1