Kidde Excellence Series Installation Sheet

Also see for Excellence Series: Installation sheet Installation sheet Installation sheet Installation sheet

Kidde Excellence Series Installation Sheet Manual pdf 1 page image

© 2023 Carrier. All rights reserved. 1 / 27 P/N 12-0201-501-4001-01 • ISS 21NOV23Excellence Series Intelligent Addressable SingleOutput Module Installation SheetEN DE ES FR IT NL PL PT SV1EN: Installation SheetFiguresFigure 1: Device overview(1) Mounting holes (×4)(2) Loop terminal block(3) Test (T) button(4) Output status LED(5) Output terminal block(6) DIP switch(7) Device status LEDDescriptionThis installation sheet includes information on the KE-IO3101Intelligent Addressable Single Output Module (device type1Oni).The module is loop powered and provides a singleunsupervised output with normally open (NO), normally closed(NC), and common (C) contacts. The module includes anintegrated short circuit isolator and is suitable for indoorinstallation.All 3000 Series modules support the Kidde Excellence protocoland are compatible for use with 2X-A Series fire alarm controlpanels with firmware version 5.0 or later.InstallationWARNING: Electrocution hazard. To avoid personal injury ordeath from electrocution, remove all sources of power andallow stored energy to discharge before installing or removingequipment.Caution: For general guidelines on system planning, design,installation, commissioning, use and maintenance, refer to theEN 54-14 standard and local regulations.Installing the moduleAlways use the NeXT System Builder application to calculatethe maximum number of modules that can be installed.The module must be installed inside a compatible protectivehousing (not supplied) − we recommend the N-IO-MBX-1 DINRail Module Box. Remember to earth the protective housing.Note: An alternative protective housing may be used providingit meets the specifications indicated in “Protective housing” onpage 3.Mount the protective housing onto the wall using a suitablemounting system for the wall characteristics.Wiring the moduleConnect the loop wires to the module as shown below. SeeTable 2 for recommended cable specifications.Table 1: Loop connectionTerminal DescriptionB− Negative line (–)A− Negative line (–)B+ Positive line (+)A+ Positive line (+)Table 2: Recommended cable specificationsCable SpecificationLoop 0.13 to 3.31 mm² (26 to 12 AWG) shielded orunshielded twisted-pair (52 Ω and 500 nF max.)Output 0.13 to 3.31 mm² (26 to 12 AWG) shielded orunshielded twisted-pair