Keysight N9038A Installation Note

Also see for N9038A: Manual Measurement guide Measurement guide Manual Installation note

Keysight N9038A Installation Note Manual pdf 15 page image

Installation Note N9038-90018 15Option HL4 - High Performance Digital Signal Processing UpgradeEnhanced Front End Control Assembly Installation19.Refer to Figure 8. Carefully install the new A15 Enhanced Front End Control board assembly,moving W27 out of the way as needed so that no components on the assembly are damaged.Make sure that the assembly connector fully engages with the A8 Motherboard connector.20.Reconnect W27 to J103 of the A23 Limiter Assembly. Torque to 10 inch-lbs.21.Reconnect W3 to J800 of the A15 Enhanced Front End Control board assembly.22.Reconnect W4 to J700 of the A15 Enhanced Front End Control board assembly.23.Reconnect W5 to J102 of the A15 Enhanced Front End Control board assembly.24.Reconnect W12 to J300 of the A15 Enhanced Front End Control board assembly.Figure 8 New A15 Enhanced Front End Control Assembly Cable LocationsThe location of J300 on the new A15 assembly may be in a different location than it was on theA15 assembly that was removed. If needed a new shorter W12 cable assembly (N9020-60059)is included with this kit.