Keysight N9030A Measurement Manual

Also see for x series: Manual Installation note Measurement guide Measurement guide Measurement guide

Contents

Keysight N9030A Measurement Manual Manual pdf 9 page image

9Demodulating AM, FM, ΦM, FM Stereo/RDS SignalsSetting Up and Making a MeasurementThe 3 Steps to Set Up and Make MeasurementsAll measurements can be set up using the following three steps. The sequence startsat the Mode level, is followed by the Measurement level, then finally, the resultdisplays may be adjusted.NOTE A setting may be reset at any time, and will be in effect on the next measurementcycle or view.Table 1-1 The 3 Steps to Set Up and Make a MeasurementStep Action Notes1 Select and Set Up theModea. Press Mode.b. Press Analog Demod.c. Press Mode Preset.d. Press Mode Setup.All licensed, installed modesavailable are shown under the Modekey.Using Mode Setup, make anyrequired adjustments to the modesettings. These settings will apply toall measurements in the mode.2 Select and Set Up theMeasurementa. Press Meas.b. Select the specific measurementto be performed.c. Press Meas Setup.The measurement begins as soon asany required trigger conditions aremet. The resulting data is shown onthe display or is available for export.Use Meas Setup to make anyrequired adjustment to the selectedmeasurement settings. The settingsonly apply to this measurement.3 Select and Set Up aView of the ResultsPress View/Display. Select adisplay format for the currentmeasurement data.Depending on the mode andmeasurement selected, othergraphical and tabular datapresentations may be available.X-Scale and Y-Scale adjustmentsmay also be made now.Table 1-2 Main Keys and Functions for Making MeasurementsStep Primary Key Setup Keys Related Keys1 Select and set up a mode. Mode Mode Setup,FREQ ChannelSystem2 Select and set up ameasurement.Meas Meas Setup Sweep/Control,Restart, Single, Cont