Keysight E5052B Installation Manual

Also see for E5052B: Service guide

Keysight E5052B Installation Manual Manual pdf 18 page image

18 Keysight E5052B Signal Source AnalyzerInstallationInstalling Front Handles/Rack Mounting Flanges2-How to Install the Rack-mount Kit (Option 1CM)The rack-mount kit includes two flanges (locking side plates) for mounting theE5052B on a rack (482.6 mm/19 inches) conforming to the EIA Standard.While referring to Figure 2-3, install the rack-mount kit by following thesesteps.Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frameof the E5052B front panel.Step 2. Use the provided screws to mount a rack-mounting flange (4) on each side ofthe E5052B front panel frame.Step 3. Remove the four bottom feet of the E5052B (lift the bar marked TAB on theinner side of the foot and slide the foot toward the bar).Step 4. Mount the E5052B on the rack.How to Install the Rack-mount and Handle Kit (Option 1CP)The rack-mount and handle kit includes both the rack-mounting flanges(locking side plates) and front handles. While referring to Figure 2-3, install therack-mount kit by following these steps.Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frameof the E5052B front panel.Step 2. Use the provided screws to mount a front handle (2) and rack-mountingflange (4) on each side of the E5052B front panel frame.Step 3. Remove the four bottom feet of the E5052B (lift the bar marked TAB on theinner side of the foot and slide the foot toward the bar).Step 4. Mount the E5052B on the rack.Use both a front handle and a rack-mounting flange in the same timecertainly. Do not attempt to install flanges or handles separately withhardware provided. Serious electrical damage will occur to the instrument.