Keys Fitness Treadmill HT901 Owner's Manual

Contents

Keys Fitness Treadmill HT901 Owner's Manual Manual pdf 7 page image

The KEYS 901 Treadmill is shipped in four pieces to make assembly easy. After opening the box, removeany packing materials from the treadmill. You should find a rear endcap (large plastic piece that fits over therear roller area), and owner’s manual packet with bolts and screws for assembly. Do not throw away any pack-ing materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electri-cal cord will easily reach an electrical outlet.Figure 1 – Assembly for main uprights1) Have a second person raise the console to the upright position and hold.2) Insert 3/4” Button Head Bolt into upright bracket and tighten loosely. Repeat for opposite side.3) Insert the TUBE SPACER inside the upright frame and line up with the bottom hole. Hold tube spacerwhile inserting the 1 1/2” Button Head Bolt and lightly tighten. Repeat for opposite side.4) After completing opposite side, tighten all four assembled bolts and the two other button head bolts thatwere present before starting. Assembly is now complete.5) Be sure to insert the SAFETY KEY before turning the power on.Figure 2 – Assembly for rear end capTo attach the rear end cap:1)Place plastic rear end cap over exposed rear roller area.2)Align holes in plastic end cap with pre-drilled holes in frame.3)Loosely tighten each screw until all four screws are lined up.Tighten all four screws snugly.CAUTION: DO NOT OPERATE TREADMILL WITHOUT SECURING REAR ROLLER HOUSING!!!Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.Assembly is now complete!7Figure 1 Figure 2Assembly, Moving Instructions