Kersten FKM 60 Operating Manual

Contents

Kersten FKM 60 Operating Manual Manual pdf 67 page image

2018-12-18 67 / 74Front sweeper FKM 60Faults / Troubleshooting ENG8.3 Fault table sweeperFault Possible causes RemedyHydraulic motor does notturnVehicle does not run. Start carrier vehicle.Hydraulic power take-off notswitched on. Switch on hydraulic auxiliary drive.Hydraulic hoses not connected. Connect hydraulic hoses.Hydraulic connector not engaged. If necessary, plug in the hydraulicconnector until it clicks into place.No hydraulic fluid in the hydraulictank.Top up hydraulic fluid in the hydraulictank.Sweeping roller turns tooslowly Speed set too low. Increase the speed at the flow controlvalve.Hydraulic fluid level too low. Top up hydraulic fluid in the hydraulictank.Leakage on the hydraulic hoses. Replace hydraulic hoses.Leakage at the hydraulic connectors.Release hydraulic connector and insertagain until it clicks into place. If leakagecontinues, check the hydraulicconnector and replace if necessary.Leakage at the hydraulic screwconnection.Slightly loosen the hydraulic screwconnection, move the hose slightly andtighten the hydraulic screw connectionagain.Contact pressure on the ground toolarge.Align the machine higher so that thesweeping roller is relieved.Carburetor adjusted. Adjust carburetor.Height adjustment stiffWheel supports not greased.Lubricate the wheel supports at thelubrication points. If necessary.additionally use creep oil and greasethe threaded spindle.Sweepings remain lying /does not sweep cleanDriving speed too high. Reduce driving speedBroom speed too high / too low. Reduce or increase broom speed.Sweeping roller height set too high. Adjust the sweeping roller heightaccording to the specifications.Collecting container set too high. Set the collection container to thecorrect height.Side brush set incorrectly. Adjust the side brush properly.