Kenmore 665.95012 Use & Care Manual

Also see for 665.92002: Use and care guide

Contents

Kenmore 665.95012 Use & Care Manual Manual pdf 11 page image

ELECTRONIC OVEN CONTROLBROIL2 3HOUR MIN__ TART O_urnsF9 10 11 121. Display2. CLOCK3. TIMER4. Oven Light/Oven Lockout5. Oven Selectors6. SELECT CLEAN TM Self-Clean(on some models)7. Temperature Setting8. Timed Cooking9. HOUR10. MINUTE11. START/ENTER12. OFF/CANCELDisplayWhen power is first supplied to the appliance, everything on thedisplay will light up for 5 seconds. Then the time of day and "PF"will appear on the display.Any other time "PF" appears, a power failure occurred. Toremove "PF" and to reset the clock, press OFF/CANCELWhen the oven is in use, this display shows time, temperatureand what command pads have been pressed.When the oven is not in use, the display will show the time of day.Start/EnterThe START/ENTER pad begins any oven function except theTimer. If not pressed within 5 seconds after pressing a pad,"START?" will appear on the display as a reminder. If not pressedwithin 5 minutes after pressing a pad, the display will show thetime of day and the programmed function will be cancelled.Off/CancelThe OFF/CANCEL pad stops any oven function except for theClock, Timer and Cooktop or Oven Lockouts.After pressing OFF/CANCEL, the display will show the time ofday or, if the minute timer is also being used, the time remaining.ClockThis is a 12 hour clock and does not show a.m. or p.m.To Set:1. Press CLOCK.2. Press the HOUR/MIN "up" or "down" arrow pads until thecorrect time of day shows on the display.3. Press CLOCK or START/ENTER.TonesTones are audible signals, indicating the following:One tone• Valid pad press= Oven is preheated• Function has been enteredThree tones• Invalid pad pressFour tones= End-of-cycle• Reminder, repeating each minute after the end-of-cycle tonesError TonesError tones indicate a problem with the electronic oven control.An error code will appear in the display.Tone VolumeThe volume can be adjusted between high and low.To Change: Press and hold DELAY START for 5 seconds. A shorttone will sound and either "Snd HI" or "Snd Lo" will appear on thedisplay. Press and hold DELAY START again for 5 seconds tochange to desired setting.To remove "Snd on", "Snd OFF", "rEP on", "Snd HI" or "Snd Lo"press any pad, and the time of day will appear on the display.Reminder TonesReminder tones are four 1-second tones which indicate that theset time has expired for a timer or a timed oven control function.TimerTo Turn Tones Off/On: Press and hold SET/OFF for 5 seconds. Ashort tone will sound and "rEP OFF" will appear on the display.Repeat to turn back on."rimed CookingTo Turn Tones Off/On: Press and hold COOK TIME. A short tonewill sound and "Snd OFF" will appear on the dispray. Repeat toturn back on.11