Kenmore 665.75002 Use & Care Manual

Also see for 665.72002: Use and care guide Use & care guide Use & care guide

Contents

Kenmore 665.75002 Use & Care Manual Manual pdf 9 page image

ELECTRONIC OVEN CONTROL11£Mp2 3 4HOUR MINCOOK iUBA¥ START Oh'="r_ STOAT8 9 10 11 121. Display2. CLOCK3. TIMER4. Oven Light/Oven Lockout5, Oven Selectors6. SELECT CLEAN TM Seff-Ciean(on some models)7. Temperature Setting8. Timed Cooking9. HOUR10o MINUTE11. START/ENTER12. OFF/CANCELDisplayWhen power is first supplied to the appliance, make sure thesurface burners are in the OFF position. Everything on the displaywill light up for 5 seconds. Then the time, "PF" and a picture of acooktop will appear on the display.Any other time "PF" and a picture of a cooktop appears, a powerfailure occurred. To remove "PF" and to reset the clock, pressOFF/CANCEL.When the oven is in use, this display shows time, temperatureand what command pads have been pressed.When the oven is not in use, the display will show the time of day.Start/EnterThe START/ENTER pad begins any oven function except theTimer. If not pressed within 5 seconds after pressing a pad,"START?" will appear on the display as a reminder, If not pressedwithin 5 minutes after pressing a pad, the display will show thetime of day and the programmed function will be cancelled.Off/CancelThe OFF/CANCEL pad stops any oven function except for theClock, Timer and Cooktop or Oven Lockouts.After pressing OFF/CANCEL, the display wilt show the time ofday or, if the minute timer is also being used, the time remaining,ClockThis is a 12 hour clock and does not show a.m. or p.m.To Set:1. Press CLOCK,2. Press the HOUR/MIN "up" or "down" arrow pads until thecorrect time of day shows on the display.3. Press CLOCK or START/ENTER,TonesTones are audible signals, indicating the following:One tone• Valid pad press• Oven is preheated• Function has been enteredThree tones• Invalidpad pressFour tones• End-of-cycle• Reminder, repeating each minute after the end-of-cycle tones