3-6 Installation and Configuration KPCI-3101 — KPCI-3104 Series User’s ManualInserting the KPCI-3101–4 series board in the computer1. To discharge any static electricity, hold the wrapped board in one hand while placing yourother hand firmly on a metal portion of the computer chassis.2. Carefully remove the antistatic packing material from the board. (It is recommended that yousave the original packing material in the unlikely event that your board requires servicing inthe future.)3. Hold the board by its edges and do not touch any of the components on the board.4. Position the board so that the cable connectors are facing the rear of the computer, as shownin Figure 3-1.Figure 3-1Inserting the KPCI-3101–4 series board in the computer5. Carefully lower the board into the PCI expansion slot using the card guide to properly alignthe board in the slot. When the bottom of the board contacts the bus connector, gently pressdown on the board until it clicks into place.CAUTION Do not force the board into place. Moving the board from side to side duringinstallation may damage the bus connector. If you encounter resistancewhen inserting the board, remove the board and try again.6. Secure the board in place at the rear panel of the system unit using the screw removed fromthe slot cover.KPCI-3101–4Series BoardRear of ComputerPCI expansion slot bus connector
