Installation SR-100i User’s ManualTorch ConnectionsPerform the following steps to connect the torch leads to the torch.Note: When making hose connections, only tighten the brass fittingsenough to make a gas seal. The fittings are subject to damageif over tightened. Also, use two wrenches when tighteningthe torch fittings to avoid damaging the torch1. Unscrew the torch handle assembly from the torch main body and slide thetorch leads through the handle.2. Attach the torch electrode lead (3/8” hose) to the torch electrode fitting on thetorch body.3. Attach the torch nozzle lead (3/16” hose) to the torch nozzle fitting on thetorch body.4. Slide the torch handle down over the connections and thread the handle ontothe torch body, being careful to avoid cross-threading the handle. Whentightening the handle, be sure to turn the handle and not the torch body. Thiswill avoid twisting the torch leads.Figure 3-3 Torch Connections3-5
