Kaco blueplanet 87.0 TL3 Manual

Also see for blueplanet 110 TL3: Manual Operating instruction Manual Manual Operating instruction

Contents

Kaco blueplanet 87.0 TL3 Manual Manual pdf 19 page image

NOTE: The minimum clearances between two devices, or the device and the ceiling or floor have already beentaken into account in the diagram.3 Fix the mount to the wall using suitable mounting fixtures from the mounting kit.NOTE: Make sure that the mount is oriented correctly.» Proceed with the installation of the unit.6.4 Installing and securing the deviceCAUTIONRisk of injury from improper lifting and transport.If the unit is lifted improperly, it can tilt and result in a fall.› Always lift the unit vertically using the openings provided.› Use a climbing aid for the chosen installation height.› Wear protective gloves and safety shoes when lifting and lowering the unit.NOTEPower reduction due to heat accumulation!If the recommended minimum clearances are not observed, the device may go into power regulationmode due to insufficient ventilation and the resulting heat build-up.› Observe minimum clearances and provide for sufficient heat dissipation.› All objects on the device housing must be removed during operation.› Ensure that no foreign bodies prevent heat dissipation following device installation.123Fig. 16: Lift the device using the opening43 Fig. 17: Fitting the device onto the mountKey1 Opening 3 Mounting bracket2 Centre of gravity 4 MountLifting and installing the unit↻ The mount has been installed.1 Lift the device using the side recesses. Observe the device's centre of gravity!NOTE: Do not lift the device by the lid or cover!2 Fit the device onto the upper mount by means of the mounting bracket. Fit the device onto the lower mountingbracket in full so that the device sits flush with its rear side on the mount ( [See figure 15] [} Page 18]).KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3KACO blueplanet 137 TL3 KACO blueplanet 150 TL3Page 19EN