KETRON XD3 Instructions Manual

Also see for XD3: Installation guide

KETRON XD3 Instructions Manual Manual pdf 77 page image

XD9-XD3 77MIDI AccordionsThe XD9 can be managed by an Accordion connected via MIDI, thanks to the fact that the attribution of the MIDI channels to the single parts ofthe keyboard, the bass transposition, the velocity and also the use of the bass voices can be controlled. The controls directly depend on the MIDIimplementation of the Accordion therefore, for very simple MIDI accordions some of the functions described hereafter may not be available.CONNECTING A MIDI ACCORDIONThe MIDI Out Output of the MIDI Accordion should be connected using a MIDI cable to the MIDI 2 In input (Keyboard) of the XD9. Enable theAccordion mode on the XD9.ENABLING THE ACCORDION AND ITS PARAMETERSThe parameters for the MIDI Accordion are accessed, from the main page of the display, by pressing F3 Utility and, from the first page of theUtility menu, by pressing F1 Accord. A new page of dedicated parameters opens. When the Accordion is connected, the Accordion mode isenabled by pressing F10, which from the disabled mode (denoted by Inactive), becomes enabled (denoted by Active). To disable the Accordionmode, press the F10 push button again. The Accordion mode calls up a number of MIDI settings that can however be modified as desired.The following parameters are available in the Utility Accordion menu:F1 Chord Mode: This is used to select two different methods for acknowledging the chords. International is the most widely used system;Belgique is to be used only to acknowledge Belgian chords. Press function push button F1 to switch from one system to theother.F2 Left Velo: This selects the velocity curve for the notes played manually using the chords of the Accordion. By pressing the F2 functionpush button repeatedly you can select the response curve. In the case of Fixed curve you can enter the fixed velocity valueapplied to the notes played using the VALUE +/- push button.F3 Right Vel: The same as for F2 Left Velo but dedicated to the notes played with the right hand, namely the lead.F4 Left Drum: When set as On, it is used to play two percussion sounds of the Drum section of the XD9 with the bass voices of the Accordionand two more voices with the Accordion chords. The two voices with relative velocity values can be selected for chords and bass.Using the CURSOR +/- push buttons, go to the voice and then select it using the VALUE +/- push buttons. Moving around againusing the CURSOR +/- push buttons you can modify the velocity value using the VALUE +/- push buttons. When a voice is to becompletely excluded, set the velocity at 0. Note: It is advisable to use the Left Drum function when the Arranger is not in use.F5 Autochord: This excludes the acknowledgement of the chords leaving the Accordion player free to play the bass and the chords manu-ally, without any automation.F6 Bas Sust: The value that can be modified using the VALUE +/- push buttons indicates the length of the Sustain on the manual bass,when the MANUAL BASS push button is in use (LED lit).F7 Bas To Ch: Set as On, it also includes the bass note in the acknowledgement of the chords, to create chords with varied bass using theBASS TO LOWEST push button.F8 Bas Octav: The value that can be modified using the VALUE +/- push buttons indicates the octave of the manual bass voice, with theMANUAL BASS push button enabled.F9 Lower Oct: For each voice assigned to Lower 1 and Lower 2, its octave can be modified using the VALUE +/- push buttons and push but-ton F9 to switch between the two parameters.F10 Accordion Mode: This enables or disables the use of the parameters for the MIDI Accordion.MIDI Accordions