KENT razor blade 26D Service Manual

Also see for 908 7099 020: Instructions for use Parts list Instructions for use

Contents

KENT razor blade 26D Service Manual Manual pdf 56 page image

ENGLISH SERVICE MANUAL54 909 6510 000(3)2007-12 Razor Blade 26D / 28D / 28CDRIVE SYSTEMDRIVE SYSTEM MOTOR CARBON BRUSH CHECK AND REPLACEMENT (Machines up to January2007)CheckDrive the machine to the appointed disposal area, and empty the recovery water tank (58) with the hose (22).Empty the solution tank (59) with the tap (36).Place the machine on a hoisting system (if available). Otherwise, drive the machine on a level floor.Turn the ignition key (12) to "0".Carefully lift the tank assembly (60).Disconnect the battery connector (63).Remove dust and debris from the drive system motor outer part (F), then disengage and remove the clamp (A) from the motor.Lift the retaining springs (B) and remove the four carbon brushes (C).Check the carbon brushes for wear. Replace the carbon brushes when: the contact with the motor armature is insufficient, thecarbon brushes are worn, the carbon brush contact surface is not integral, the thrust spring is broken, etc.ReplacementIf necessary, remove the nuts (D) and disengage the lead-in wires (E), then remove the carbon brushes.ResetAssemble the components in the reverse order of disassembly.S3013471.2.3.4.5.6.7.8.9.10.11.