SERVICE MANUAL ENGLISHRazor Blade 26D / 28D / 28C 909 6510 000(3)2007-12 37RECOVERY WATER SYSTEMVACUUM SYSTEM MOTOR DISASSEMBLY/ASSEMBLY (starting from S/N ..........)DisassemblyDrive the machine to the appointed disposal area, and empty the recovery water tank (58) with the hose (22).Empty the solution tank (59) with the tap (36).Drive the machine on a level floor.Turn the ignition key (12) to "0".Disconnect the vacuum hose (23) from the squeegee (24).Carefully lift the tank assembly (60).Disconnect the battery connector (63).Disconnect the connector (D) from the vacuum system motor.Remove the screws (A), then remove the recovery water tank (B) with the vacuum hose (C).Remove the screws (E) and recover the washer.Remove the vacuum motor cover(F).Recover the Filter (G) and the gasket (H).Remove the vacuum system motor (I), the acoustic insulation pipe (J) and the acoustic insulation panel (K)Check the gasket efficency (L) if necessary, replace them.AssemblyAssemble the components in the reverse order of disassembly, and note the following:If necessary, clean the filter (G) before assembling it (see the procedure in the relevant paragraph).S301338A1.2.3.4.5.6.7.8.9.10.11.12.13.14.15.•
