KENT MAXX Instruction Handbook For Installation, Operation And Maintenance

Contents

KENT MAXX Instruction Handbook For Installation, Operation And Maintenance Manual pdf 5 page image

Installation InstructionsTo ensure purer water throughout the service cycle, KENT MAXX is equipped with an in-built UV Fail Alarm which gets activated in an event of UV lamp failure. In case the UV lampmalfunctions, the purification process automatically stops and purifier starts emitting ashort beep at an interval of every 2 seconds.UV Fail AlarmUnder such circumstances, switch off the purifier and call the service technician for help.The purifier will stop purification in such a situation.KENT MAXX has an in-built feature that sounds an audible alarm to indicate thereplacement time of filters. This alarm is audible after 700 hrs of filter use. The FilterChange Alarm works as follows:Gives 4 short beeps after every two seconds lasting upto 30 seconds. The alarm getsactivated after every 2 hours of use.Filter Change AlarmUnder such circumstances, the purifier will not function unless the filters are changed.2 Sec. 2 Sec. 2 Sec. 2 Sec.30 Sec. 30 Sec.Slot holesComputer Controlled Operation65KENT MAXX is a convenient and easy-to-install wall mounting model.Recommended Site Preparations:100-300 V AC, 50-60 Hz single phase AC supply not more than 3m away from thepoint of installationRaw water supply with ½ inch nipple not more than 3m awayInstallation space as per the dimensions of the purifierWall/ plane surface for mounting screws and holding the machine. Avoidinstallation on wooden and metallic standsFor optimum inlet pressure, source water tank should be at least 10 ft above thepurifier installedInstall the purifier near a sink for easy availability of inlet water linesThe system and installation must comply with applicable state and local laws &regulation.nnnnnnnInstallation Procedure:1. Screw in two 10x50 self taping screws, 5.4 inches (138 mm) apart horizontally.2. Wall-mount the purifier with the help of slot holes given on the back side.3. Fasten the SS ball valve to ¼ inch port of 3-way connector.4. Attach threaded end of 3-way connector to raw water supply andplug off the other end or connect to a tap.5. Now connect one end of pipe to SS ball valve and other end to elbow fitting connectorlabeled as WATER IN, on the left side of purifier.6. Turn on the lever given on SS ball valve to initiate the water flow to purifier.To ensure the delivery of purer and healthier water, a micro-processor is installed in thepurifier that performs the following functions:-UV Stabilization Delay: To ensure that the UV lamp is pre-heated and is working at itsoptimum before it starts disinfecting water, the controller provides a two second delayto UV lamp when a purifier is switched on. During this period, only UV lamp is on and allother electrical devices of purifier are switched off and no water flows through.Purification Delay: To ensure that the water lying idle in the internal pipes and the UVchamber is thoroughly disinfected before being passed onto the storage tank, thesystem provides approximately 5 seconds Purification Delay when the purifier isswitched on. During this period, all electrical devices except UV lamp are switched offand UV lamp kills the micro-organisms present in water inside the UV chamber. After thisdelay, all other electrical devices such as solenoid valve etc., get activated and thenormal purification process starts.Audible Alarm: Microprocessor also controls the activation of UV Fail Alarm and FilterChange Alarm.Please call the service technician once the Filter Change Alarm is activated and get the filtersreplaced. In case the filters are not replaced within next 60 hours of operation, the purifierstops functioning to avoid the delivery of impure water and emits a beep continuously.

/ 6

Related manuals for KENT KENT MAXX