ENGLISH INSTRUCTIONS FOR USE12 146 3082 000(2)2007-06 Edge 28BMAINTENANCEThe lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.The following table provides the scheduled maintenance. The intervals shown may vary according to particular workingconditions, which are to be defined by the person in charge of the maintenance.WARNING!To carry out maintenance procedures, the machine must be off and, if necessary, the batteries must bedisconnected.Moreover, carefully read the instructions in the Safety paragraph.All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised ServiceCenter.This Manual describes only the easiest and most common maintenance procedures.NOTEFor other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that canbe consulted at any Service Center.SCHEDULED MAINTENANCE TABLEProcedure Every 10hoursEvery 50hoursEvery 200hoursEvery 400hoursBattery charger cable checkSide and main broom height check and adjustmentSkirt height and operation checkDust filter cleaning and integrity checkHopper gasket checkFilter shaker operation check (*)Drive belt and clutch visual inspection (*)Drive system belt tensioner adjustment (*)Nut and screw tightening check (*) (1)Motor carbon brush check or replacement (*)(*): For the relevant procedure, see the Service Manual.(1): And after the first 8 hours.BATTERY CHARGER CABLE CHECKCarefully check the battery charger cable (18) and the relevant plug for wear, cuts, cracks or other damages.If the battery charger cable or the relevant plug is damaged, contact the Kent Service Center.
