KENT EXCELL Mineral RO 11003 Instruction Handbook For Installation, Operation And Maintenance

Contents

KENT EXCELL Mineral RO 11003 Instruction Handbook For Installation, Operation And Maintenance Manual pdf 5 page image

5UV Fail Alarm*To ensure delivery of purer and healthier water, a micro-processor is installed in the purifier thatperforms the following functions: -UV Stabilization Delay: To ensure that the UV lamp is pre-heated and is working at its optimumlevel before it starts disinfecting water, the controller provides a two seconds delay to UV lampwhen the purifier is switched on. During this period, only the UV lamp is switched on and otherelectrical devices of the purifier are switched off.Purification Delay: To ensure that the idle water lying in the internal pipes and in the UV chamber isdisinfected before being passed into the storage tank, the system provides 5 second delay whenthe purifier is switched on. During this time, the UV lamp kills all micro-organisms that may be inthe water inside UV chamber. After this delay, all other electrical devices such as booster pump andsolenoid valve are switched on to start normal purification process.Audible Alarm: The controller also controls the timing of UV Fail Alarm and the Filter Change Alarm.Computer-Controlled Operation*n nn nThe purifier is automatically shuts off when The purifier automatically restarts whenthe storage tank is full water level drops below the maximumThe purifier does not start when inlet water The purifier does not allow any water rejection2 in absence of electricity or when tank is fullsupply pressure falls below 0.3 kg/cmAutomatic OperationKENT TM+Excell Mineral RO has an in-built feature that sounds an audible alarm if the UV lamp malfunctions.This feature is provided to ensure purity. This UV Fail Alarm will sound as following:Two short beeps after every two seconds.In case such an alarm is audible, kindly switch off the purifier and call the service technician for help.The purifier will stop its purification process in such a circumstance.2 Sec. 2 Sec. 2 Sec.2 Sec.Filter Change Alarm2 Hours30 Sec. 30 Sec.KENT TMExc Mineral RO has an in-built feature that sounds an audible alarm to indicatereplacement time for filters. This alarm will be audible afterThe Filter Change Alarm will sound as following:4 short beeps after every two seconds; for 30 seconds. The alarm will repeat after every 2 hours of use.In case such an alarm is audible, please call the service technician and request him to change thefilters of the purifier. However, if the filters are not changed within the next 60 hours of operation, thepurifier will stop functioning to ensure purity and hygiene. The following alarm will be audibleafter 60 Hrs.A continuous beep for an infinite time.In case, such an alarm is audible, kindly switch off the purifier and call the service technician to replacethe filters. In such a circumstance, the purifier will not function unless the filters are changed.+ell700 hrs of use since the last filter change(or since the time of installation).TM+The Excell Mineral RO Water Purifier is a product of advanced technology, which ensuressafe and clean drinking water. The purifier is easy and convenient to install.Recommended Site Preparations :100-300 V AC, 50-60 Hz connection not more than 3m away from the point of installation of purifierRaw water supply with ½ inch nipple not more than 3m awayDrain for rejected water not more than 3m awaySpace as per dimensions of the purifierWall/plane surface for mounting two screws and holding the machineThe system and installation need to comply with state and local laws and regulationsSpecific Instructions:TM+Excell Mineral RO is an under the sink purifier. Make sure that it is only mounted on awall. Avoid installation on wooden and metallicstandsFor optimum performance and minimum inlet pressurerequired, ensure that the raw water supply tank is at least10 ft above the level at which the purifier is installedIt is preferable to install the purifier near a sink so thatfaucet can be mounted on the sink and the inlet and rejectwater lines are easily availableInstallation Instructions:Screw in the two 10x50 self taping screws on a samehorizontal level at a distance of 246 mm from each otherin the wall. This can be preferably done under the kitchensink.Carefully hang the purifier on the wall with the help of wallmounting slot holes present on the back side of thepurifier as shown in the figure 1.Fix the SS ball valve to the ¼ inch port of the 3-wayconnector.Connect the 3-way connector to the raw water supply asshown in the figure 2. The threaded end of the 3-way connector is fitted in line with the raw watersupply. The other end can be connected to a tap or can be plugged off if not required.Now connect one end of the white pipe to the SS ball valve and other end to the inlet of the rightmost sediment filter (labeled as No.1 in the system flow diagram) (Note: white pipe is for rawwater supply).Similarly, connect one end of the blue pipe to the outlet of the flow restrictor tube (labeled as No.11 in the system flow diagram) and leave the other end of the pipe in the drain. (Note: Blue pipe isfor reject water)Make a drill of 11 mm on the top of the sink or kitchen bed where the faucet (labeled as No. 11 in thesystem flow chart) can be installed conveniently as per drawing. Secure the faucet to the sink, bytightening the brass nut washer.Tighten the 90 degree ball valve to the tank and connect it to the outlet of the purifier asshown in the drawing.KENTKENTnnnnnnnnn1.2.3.4.5.6.7.8.Installation Instructions6246 mmFigure 1* Tested & Certified by TUV-SUD South Asia (P) Ltd.

/ 7

Related manuals for KENT EXCELL Mineral RO 11003