Menu
K9Safety K9Caller Operator's Manual
Also see for K9Caller: Installation manualConfiguration manual
                | |
The K9 features can be activated and deactivated by pressing and holding the control switchbutton for 2 seconds while the ignition is on. This will toggle activation/deactivation eachtime. While activated the K9 features such as hot temperature alert, hot temperature start, anddoor pop are ready to be triggered and the blue L.E.D. on the control switch will light steady.While deactivated the K9 features will be turned off and the L.E.D. will not be lit. The controlswitch will also trigger the alert delay if the system has triggered the hot temperature alert(horn honk, window down, etc) which will delay the alert from triggering for 5-10 minutesdepending on programming.The Keychain remote is used to receive high temperature alert notification, turn On/Off thesecurity system tied to all four doors, remote check vehicle cabin temperature, or remotelyauto start the vehicle (Alert receive range is up to 1500ft and keychain transmit range isup to 1000ft depending on environment).There are five buttons and several icons on the keychain remote which perform certain func-tions on the system or indicate system status.Button #1 is used to turn On the vehicle security system which is connected to all entry doors.Button #2 is used to turn Off the vehicle security system.Button #3 is used for door pop or trunk pop.Button #4 is used to remotely auto start the vehicle.Button #5 is used to check the last signal including, security armed/disarmed, engine autostart active, and cabin temperature.This button can also be used to change the ECU state in/out of valet which will affect thenormal operation of the security system. It will not affect the systemís ability to normallyoperate the temperature auto start or temperature alert. Pressing and holding button # 5 willscroll through the options at approximately 1 per second. To access you must hold button # 5until the desired parameter is displayed then release button # 5Note the following features are not accessible in remote lockout mode and no changescan be made via the remote.PSV, VAL, Setting the Call Temperature, Setting the Hot Start TemperatureKeychain RemotePage 7 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved