Menu
K9Safety K9Caller Operator's Manual
Also see for K9Caller: Installation manualConfiguration manual
                | |
The antenna shows status of the alarm functionsand is used to enter programming features, valetoverride and emergency disarm.If your remote is lost or not functioning and youralarm is armed, you can enter the vehicle, thealarm will sound, and the auto engine run will shutdown if already running, turn on the ignition key,and hold the antenna button for approx 10 sec-onds.There are three user controls that operate the various features of the system.Some features can be control by more than one devices. The user control devices are thecontrol switch, the remote control (2-way & 1-way) and the antenna.The control switch allows the user to activate and deactivate thek9system, trigger the alert delay, and display k9system status.The 2-way remote allows the user to activate anddeactivate the k9system, receive alert signals checktemperature, arm/disarm the alarm system, set tem-perature thresholds, and remote start the vehicle toname a few. Please see the page 5 for more detail.User Controls DescribedPage 6Two Way Antenna Button and LEDStatus LEDActivation &Alert Delay SwitchAlarm StatusLEDProgramButtonValet mode should be used whenever the vehicle is sent for maintenance or repair as itwill prevent the auto start, door pop, and alarm from functioning. After service, rememberto take the system out of Valet Mode. To put the system in or out of Valet, Turn on theignition and press and hold the antenna button for 5 seconds. The control switch LED willflash while in valet. Repeat the process to take the system out of Valet mode.System Valet Mode: |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved