Kärcher Puzzi 10/1 User Manual

Also see for Puzzi 10/1: User manual User manual Manual Original instructions Manual

Contents

Kärcher Puzzi 10/1 User Manual Manual pdf 5 page image

– 5" CAUTIONRisk of injury and damage! Observe theweight of the appliance when you transportit.IllustrationÎ For transport, place suction pipe on thecarrying handle and place the spray/suction hose on top of the appliance.Wind up the mains cable and hook itinto the cable hook.Î When transporting in vehicles, securethe appliance according to the guide-lines from slipping and tipping over." CAUTIONRisk of injury and damage! Note the weightof the appliance in case of storage.This appliance must only be stored in inte-rior rooms.! DANGERDanger of injury by electric shock.First pull out the plug from the mains beforecarrying out any tasks on the machine.Î Remove the lid.Î Remove the wastewater container fromthe appliance.Î Regularly clean the lint trap using abrush.Î Unscrew the fresh water sieve.Î Regularly clean the fresh water sieveunder running water.Î Unscrew the covering nut.Î Clean nozzle mouthpiece.! DANGER– Danger of injury by electric shock.First pull out the plug from the mains be-fore carrying out any tasks on the ma-chine.– Get the electrical components checkedand repaired only by authorised cus-tomer service persons.Î Check the receptacle and the fuse ofthe power supply.Î Check the power cable and the powerplug of the device.Î Turn on the appliance.Î Fill up fresh water reservoir.Î Check the couplings on the spray hosefor proper seating.Î Clean or replace nozzle tip.Î Clean the sieve in the fresh water reser-voir.Î Spray pump defective, contact after-sales service.Î Clean nozzle mouthpiece.Î Check the correct positioning of the lid.Î Clean seal on lid and surface on the ap-pliance.Î Clean the fluff filter.Î Check suction hose for blockages;clean if required.Î Fill up fresh water reservoir.Î Add the defoaming agent into thewastewater container or fill up the con-tainer for the defoaming agent.TransportStorageCare and maintenanceClean the fluff filterCleaning the fresh water sieveCleaning the nozzleTroubleshootingAppliance is not workingNo water exiting from nozzleSpray stream one-sidedInsufficient vacuum performanceSpray pump loudHeavy formation of foam in thewastewater container15EN

/ 7

Related manuals for Kärcher Puzzi 10/1