– 4Î Connect the manifold (with suction pipeand nozzle) to the suction hose.Î Connect the coupling of the spray hosewith the manifold and snap in place.Î Fill approx. 2 litres of fresh water intothe fresh water reservoir.Do not add any detergents.Î Press the spray switch to switch on thespray pump.Î Hold floor nozzle over a drain.Î Activate lever on bender and flush theappliance for appr. 1 to 2 minutes.Î Turn off the appliance.Î Flush appliance.Î Empty the wastewater container andclean it under running water.Î Empty the fresh water reservoir.Î Clean the outside of the appliance witha damp cloth.Î Remove all water from the applianceprior to longer periods of non-use toavoid offensive odours.Î Allow appliance to dry thoroughly: Re-move or move lid sideways.Î Place the appliance in a dry room andsecure it from unauthorized use.Î Spray and suction off detergent solutionin one work cycle.Note: Repeated suctioning without spray-ing will shorten the drying time.Î Apply detergent solution with suctionturbine turned off and soak for 10 to 15minutes.Î Clean the surface just like with normalsoiling.Î In order to further improve the cleaningresult, the surface can be recleaned us-ing clear, warm water.Î Puzzi 10/1 only:Attach hand nozzle instead of the floornozzle.Î With sensitive materials, use less deter-gent and spray the surface at a distanceof approx. 200 mm. Then simply vacu-um off.– Highly soiled spots should be pre-soaked and the detergent solutionshould soak 5 to 10 minutes.– Always work from the light to the shade(from the window to the door).– Always work from the cleaned to the un-cleaned surface.– The more sensitive the surface (orientalrugs, berbers, upholstery material) thelower the cleaning solution concentra-tion should be.– Rugs with jute backing can shrink if toomuch water is used and can bleed col-ours.– Brush high-fiber rugs in the direction ofthe weave after cleaning (using a fiberbrush or a scrubber).– Water-proofing the fabric using CareTex RM 762 after the wet cleaning pre-vents a quick resoiling of the textile sur-face.– Do not step on cleaned surfaces untilthey have dried and do not place furni-ture on them to avoid pressure spots orrust stains.For further information, please requestproduct information sheet and EU safetydata sheet of the relevant detergent.Flush applianceAfter each operationStoring the ApplianceCleaning methodsNormal soilingStrong soiling or stainsUpholstery cleaningCleaning tipsDetergentCarpet and upholsterycleaningRM 760 powderRM 760 tabsRM 764 liquidDefoaming RM 761Waterproofing carpets RM 76214 EN