– 7Suspend end of detergent suction hosein a container filled with detergent. Use spray lance with pressure regula-tion (Vario Power). Turn the spray lance to "Mix" position.Note: This will mix the detergent withthe water stream.Note: If required, the washing brushes canbe used to work with detergent. Spray the detergent sparingly on the drysurface and allow it to react, but not to dry. Spray off loosened dirt with the high-pressure jet. Release the lever on the trigger gun. Lock the lever on the trigger gun. During longer breaks (more than 5 min-utes), also turn the appliance off usingthe "0/OFF" switch.CautionOnly separate the high-pressure hose fromthe trigger gun or the appliance while thereis no pressure in the system. After working with detergent, suspenddetergent suction hose in a containerfilled with clear water, switch the appli-ance on for around 1 minute once thespray lance has been removed andrinse until water runs clear. Release the lever on the trigger gun. Turn off the appliance "0/OFF". Turn off tap. Press the lever on the trigger gun to re-lease any remaining pressure in thesystem. Detach the appliance from the watersupply.Caution: When disconnecting the sup-ply or high pressure hose, warm watermay leak from the connections after op-eration. Lock the lever on the trigger gun. Pull out the mains plug.CautionIn order to prevent accidents or injuries,keep in mind the weight of the applianceduring transport (see Specifications). Lift appliance by the carrying handleand carry it. Pull the appliance by its transport han-dle. Secure the appliance against shiftingand tipping over.Recommended cleaning methodInterrupting operationFinish operationTransportWhen transporting by handWhen transporting in vehicles9EN