6 EnglishMount loose parts delivered with applianceprior to start-up.Illustrations on Page 5IllustrationÎ Insert the transport handle and screwin.IllustrationÎ Insert the transport wheels and lockthem.Î Attach the wheel caps.IllustrationÎ Pull out the clamp for the high-pressurehose from the trigger gun (e.g. a smallscrewdriver).IllustrationÎ Connect high pressure hose to triggergun.Î Push the clamp in until it locks. Checkthe secure connection by pulling on thehigh-pressure hose.According to the applicable regula-tions, the appliance must never beused on the drinking water supplywithout a system separator. Use asuitable system separator manufactured byKÄRCHER; or, as an alternative, a systemseparator as per EN 12729 Type BA. Waterflowing through a system separator is con-sidered non-drinkable.Note: Impurities in the water can damagethe high-pressure pump and accessories.For protection, the use of the KÄRCHERwater filter (optional accessory, order no.4.730-059) is recommended.Observe regulations of water supplier.For connection values, see type plate/tech-nical data.Î Use a fibre-reinforced water hose (notincluded) with a standard coupling.(Minimum diameter 1/2 inch (13 mm),minimum length 7.5 m).Î Screw the coupling unit (supplied) tothe water connection on the appliance.Î Push the water supply hose onto thecoupling unit, then connect it to the wa-ter supply.CautionNever operate the high-pressure cleanerwhen the tap is turned off as dry running willdamage the high-pressure pump.Î Connect the high pressure hose to thehigh pressure connection of the appli-ance.Î Push the spray lance into the triggergun and fasten it by turning it through90°.Î Completely open the water tap.Î Insert the mains plug into the socket.Î Turn on the appliance “I/ON”.Before Startup Water supplyWater supply from mainsStart up