Kärcher CV 66/2 Service Manual

Also see for CV 66/2: Instruction manual Manual Original instructions Instructions Original instructions

Contents

Kärcher CV 66/2 Service Manual Manual pdf 5 page image

English 5The operating panel includes the appliance switch, the fuses forthe brush motor and the suction turbines and the ring core throt-tles. The operating panel is connected to the appliance via a har-ness, which is routed along the right handlebar.Î Remove the marked screws.Î Pull the cover off toward the back.Î Reroute the mains cable during removalIf the mains cable or the mains plug are damaged, they must bereplaced.Î Remove the cover (see "Disassembly of operating panel")Î Carefully open cable tie (cut)Î Disconnect the connectors on the supply lineÎ Separate the protective conductor from the grounding clip.For this, loosen the nut and pull of all the ring ferrules. Theprotective conductor is installed last.Î Remove the traction relief: Unscrew the locknut, hold againsttraction reliefÎ Pull the mains cable out toward the backÎ Route a new mains cableÎ Restore the protective conductor and the connectionsÎ Bundle the cables with the harnessÎ Reinstall the coverA defective appliance switch must be completely replaced.Î Remove the cover (see "Disassembly of operating panel")Î Carefully open cable tie (cut)Î Remove the connections from the switchÎ Press together the locking nose on the switchÎ Pull the switch from the holder toward the bottomÎ Insert new switch - observe the installation position: Pin point-ing toward the bottom, use mark "Off" on the operating panelas a guide5.2 Remove operating panel5.3 Replacing the mains cable5.4 Replace appliance switch