K-array Redline KL18ma User Manual

Also see for Redline KL18ma: User manual

Contents

K-array Redline KL18ma User Manual Manual pdf 12 page image

AcousticsPower handlingMax powerImpedanceOperating frequency rangeFrequency rangeSPL 1W/1mtMaximum SPLCross overTypeFrequencyTransducersLow frequencyHigh frequency (KR200)Audio InputConnectorsWiringAudio powered OutputConnectorWiringRemote control InputConnectorsPower InputConnectorsAmplifiersTypeSubwoofer powerSatellite power outputProtectionsAC powerOperating rangeMax continuos and burst currentPhysicalMeasuresWeight800(sub) + 500(sat) w11200(sub) + 1200(sat) w8 (sub) + 8 (sat)30Hz - 19 KHz +/- 3dB (preset relating)35Hz - 19 KHz +/- 3dB (preset relating)97 dB(sub) 101 dB(sat)127dB continuos - 133 dB peakDSP controlled preset relating150 Hz minimum (preset relating)1 x 18" Neodymium speakers with 3" voice coil32 x 2" Neodymium speakers with 0,75" voice coilmale + female parallel 3 poles balanced XLR= ground / = hot / = coldFemale Speakon= CH1+ / = CH1- / = N.C. / = N.C.1 x female 8 poles RJ452 x PowerCon IN/OUT (max out 14 A)1 modules class D - DSP controlled1000 Watt1000 WattDynamic limiter, over current, over temp, short circuitsStandard 210 - 240 Vac 50Hz (standard)Standard 6A(>10 sec) - 12A (<1 sec)46.5 x 46.5 x 58.5 cm (KL18ma) 5.5 x 7 x 200 cm (KR200)20 Kg (KL18ma) 9 Kg (KR200)23456788W WPin1 Pin2 Pin3Pin1+ Pin1- Pin2+ Pin2-Optional 100 - 120 Vac 60Hz (optional)Optional 10A(>10 sec) - 20A (<1sec)Notes for data1. Power handling is measured following AES standard conditions: transducers driven continuously for two hours with a band-limited noise signal having 6 dB of crest factor.2. Max power is the maximum RMS applicable power for a musical signal, the referement signal is the one proposed by EIAJ standard.3. Recommended maximum operating frequency range. Response depends on loading conditions and room acoustics.4. Free field measured with 1/3 octave frequency resolution at 2 mt.5. Measured@4 mt then scaled@1 mt.6. Measured with audio source @1 mt.7. This is the frequency in which the transducers produce the same sound pressure level (measured@2 mt).8. Amplifier wattage rating is based on the maximum unclipped burst sine wave RMS voltage that the amplifier will produce into the nominal load impedance .HP Sound Equipment s.r.l. - www.k-array.comViale Roma 7/i 50037 San Piero a Sieve (Firenze) Italy - tel +39 055 8487222 fax e-mail: info@k-array.com+39 055 84872388. TECHNICAL DATAENGLISHpag. 12USER'S MANUALREV. A