JVC XV-NA70BK Instructions Manual

Contents

Preparations9PreparationsTo use the remote control unit for TVoperationSetting the remote control signal for operating yourTV1 Set the TV - DVD switch to “TV.”2 While holding down TV/VIDEO - CANCEL,enter the manufacturer code of your TV listedbelow by using the numeric buttons (0 to 9),and then press ENTER.Example:To enter the manufacturer code “01”: Press “0,” “1,” thenENTER.Manufacturer code list3 Release TV/VIDEO - CANCEL.4 Try to operate the TV by pressing TVSTANDBY/ON .If your TV turns on or off, you have successfully set thecontrol signal.NOTES• The initial manufacuturer code of the unit upon purchase is“JVC” (01).• If there is more than one code listed for the manufacturer ofyour TV, try them one by one until you succeed.Operating the TVSet the TV - DVD switch on the remote control unit to “TV.”The following buttons can be used for operating the TV.To control the volume of a JVC’s amplifier orreceiverPressing the AMP VOL + button raises the audio volume of aJVC’s amplifier or receiver, while pressing the – button lowers thevolume.Manufacturer No. Manufacturer No.AIWA 36 MIVAR 29BEIJING 22 NEC 20CCE 02 NOBLEX 22CHANGHONG 34 NOKIA 31DAEWOO 17, 37 PANASONIC 04, 11FERGUSON 27 PEONY 34, 38, 39FINLUX 30 PHILCO 10, 17, 21FUNAI 32 PHILIPS 02GRADIENTE 15, 20 RCA 05GRUNDIG 19SAMSUNG12, 33, 34,35HITACHI 10ITT 28 SANYO 13, 16JINXING 38 SEARS 13JVC01, 23, 24,25SHARP 06SONY 07KONKA 40 TCL 41LG (GOLDSTAR) 18 THOMSON 26MAGNAVOX 02 TOSHIBA 08, 14MITSUBISHI 03 ZENITH 09TV/VIDEO-CANCELAMP VOL +/-ENTERTV STANDBY/ONTV-DVDNumeric buttonsTurns the TV on or off.Switches the TV input mode between TV andVIDEO.Selects the TV channels directly.*For some TVs, pressing “+10” functions as the“100+,” while “10” functions as the ENTER buttonif your TV requires pressing the ENTER buttonafter selecting a channel number.Mutes the TV sound.Changes the TV channels.Adjusts the TV sound volume.TV DVDTVTV/VIDEOCANCEL~TV11TV-/--10TV00MUTING+10CH+CH-VOL - VOL+AMPVOL