JVC VN-T216VPRU Instructions Manual

Also see for VN-T216VPRU: Specifications Specifications Instructions Quick guide Instructions

11Adjusting the Camera PositionThe dome camera has three axes for positioning the camera. Whilemonitoring the picture on the monitor, adjust the camera position as follows:ü Pan Adjustment (A) For Wall Mount and Tilted Ceilings Rotate the lensbase (maximum360° ) until you are satisfied with the field of view.ü Horizontal Rotation (B) Rotate 3D assembly in the base. Do not turnassembly more than 360° as this assembly may cause the internalcables to twist and disconnect or break.ü Tilt Adjustment (C) After loosening the thumbnuts, position the camera as desired,then finger –tighten the thumbnuts to set the position.Caution Do not turn the lens more than 360° as this may cause internalcables to disconnect or break.Caution Retighten the locking screws to prevent loss of adjustment.Mounting the Cameraü Place the guide pattern sticker (supplied) on the mounting surface andmark three holes according to the guide pattern sticker. Then fasten thesticker to the mounting surface with screws.ü Connect the Safety Wire (Fall Prevention Wire, not supplied) to thecamera and the ceiling.ACB