JVC VN-H37U Instructions Manual

Also see for VN-H237VPU: Specifications Specifications Guide Installation instructions Instructions

70Internet Explorer SettingLED State PageThis page sets the [STATUS] LED indication of the camera.This page can be used during access using AadminB or AoperatorB.Memo:● Press the [OK] button to enable the new settings. If you press the [Cancel] button, your changes arecanceled and the current camera settings are displayed.* The [Set values] in bold letters are factory defaults.Settings (continued)ABClick [Advanced Settings] and [LED State].Status LED Allow to check and set the [STATUS] LED indication of the camera.A LED State Turns the [STATUS] indicator On or Off when the camera is operating.Enable : Continues to light when the camera is operating.Disable : Turns the indicator Off after the camera has started.[Set values: Enable, Disable]B Identify Unit If you wish to blink the [STATUS] indicator of the camera, set this option toABlinkB. This may occur if you wish to visually check the camera operationwhen configuring the camera from the PC.[Set values: Enable, Blink]Memo:● If you have set the [LED State] to ADisableB, the indicator does not lighteven when you set the [Identify Unit] to ABlinkB.