JVC MX-KC45 Instructions Manual

Also see for CA-MXKC45: Service manual Instructions

Contents

5Getting StartedConnecting the AM AntennaRear Panel of the Unit• Even when connecting an outside AM antenna, keep the indoor AM loop connected.CAUTION:• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.Connecting the Speakers1. Open each of the terminals to connect the speaker wire leads.2. Connect the speaker cords to the Speaker terminals of the Unit.Connect the gray (+) and gray with black stripe (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHTon the System.Connect the gray (+) and gray with black stripe (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT onthe System.3. Close each of the terminals.CAUTIONS:• A TV may display irregular colors if located near the speakers. If this happens, set the speakers awayfrom the TV.• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.AM loop antenna (Supplied)Attach the AM loop to its base by snapping thetabs on the loop into the slot in the base.Turn the loop until youhave the best reception.AM antenna wire (not supplied)If reception is poor, connect the outside antenna.Right side (rear view) Left side (rear view)Gray withblack stripeGrayGray withblack stripeGray