JVC MX-G50 Instructions Manual

Also see for MX-G50: Service manual Instructions for use

– 11 –Listening to FM and AM BroadcastsTuning in a Station1 Press FM/AM.The unit automatically turns on and tunesin the previously tuned station (either FMor AM).• Each time you press the button, theband alternates between FM and AM.2 Start searching for stations.On the unit:Press and hold TUNING + orTUNING – for more than 1second.On the remote control:Press and hold 4 or¢ for more than 1 second.The unit starts searching for stationsand stops when a station of sufficientsignal strength is tuned in.If a program is broadcast in stereo, the ST (stereo)indicator lights up.To stop during searching, press TUNING + or TUNING –(or 4 or ¢ on the remote control).When you press TUNING + or TUNING –(or 4 or ¢ on the remote control) briefly and repeatedlyThe frequency changes step by step.To change the FM reception modeWhen an FM stereo broadcast is hard to receive ornoisy, press FM MODE on the remote control sothat the “MONO” appears and MONO indicatoralso lights up on the display. Reception improves.To restore the stereo effect, press FM MODE again so thatthe “STEREO” appears on the diplay and the MONOindicator goes off from the display.In this stereo mode, you can hear stereo sounds when aprogram is broadcast in stereo.Presetting StationsYou can preset 30 FM and 15 AM stations.In some cases, test frequencies have been already memorizedfor the tuner since the factory examined the tuner presetfunction before shipment. This is not a malfunction. You canpreset the stations you want into memory by following thepresetting method.• There is a time limit in doing the following steps. If the settingis canceled before you finish, start from step 1 again.On the unit ONLY:1 Tune in the station you want to preset.• See “Tuning in a Station” above.2 Press SET.3 Press PRESET + or PRESET –to select a preset number.4 Press SET again.The tuned station in step 1 is stored in the preset numberselected in step 3.• Storing a new station on a used number erases thepreviously stored one.When you unplug the AC power cord or if a powerfailure occursThe preset stations will be erased in a few days. If this happens,preset the stations again.Tuning in a Preset Station1 Press FM/AM.The unit automatically turns on andtunes in the previously tuned station(either FM or AM).• Each time you press the button, theband alternates between FM and AM.2 Select a preset number.On the unit:Press PRESET + or PRESET –.On the remote control:Press the number buttons.Ex.: For preset number 5, press 5.For preset number 15, press +10then 5.For preset number 20, press +10,then 10.For preset number 25, press +10,+10, then 5.For preset number 30, press +10, +10, then 10.TUNINGFM MODESETPRESET1 2 34 5 67 8 910 +10SETPRESET