JVC MC-8200LU Instructions Manual

Also see for MC-8200LU: Instructions Instructions Instructions Service manual

Contents

E31ENGLISHError Codes10-2. Error code list01 UP/DOWN rotary sensor does not change02 Left slit sensor does not change03 Right slit sensor does not changeC U 04 UP/DOWN motor does not function07 UP/DOWN motor drive short-circuits and over-current is detected08 UP/DOWN operation exceeds the predetermined duration09 Lower limit sensor turn on during UP/DOWN operation10 Tray lock release not possibleC L 11 Tray lock impossible, or lane change not possible12 Tray lock does not exist at the initial position during carrier movement20 Catcher (right → left) movement operation exceeds the predetermined duration21 Catcher (left → right) movement operation exceeds the predetermined duration22 Catcher (right → left) convergence operation exceeds the predetermined duration23 Catcher (left → right) convergence operation exceeds the predetermined duration24 Catcher (right → left) tray rotary sensor does not change25 Catcher (left → right) tray rotary sensor does not changeC C 26 Right catcher sensor does not turn on27 Left catcher sensor does not turn on28 Catcher motor (right → left) does not function29 Catcher motor (left → right) does not function30 Tray does not exist31* 2 Magazine insertion incomplete, or sensor defective32 Over-current is detected during catcher motor operation41 Destination-unknown tray exists on the carrierC D42 No disc in the tray43 Flip tray does not exist80 During the flip raise operation, the expected time required is overF81 During the flip descent operation, the expected time required is overE 50 Mail Slot ejecting is not possibleM L 51 Mail Slot loading is not possibleT 52 Destination-unknown tray exists in the Mail Slot60 Destination-unknown tray exists in the Drive and the control cable of the Drive is disconnected.T61 Tray removal is not possible at the drive position(D#)*1C 62 Disc clamp of the drive does not functionE 63 Drive ejection is not possibleD 64 Failure to remove the disc from the driveS 65 Spindle motor fails to stop (Ejection inhibited status)Device DescriptionDevicepart Errorcode*1: # represents the drive number.*2: Check the magazine loading condition. (a See “9-1. Ejecting/loading the magazines” on page E27.)These errors indicate that the disc is not being moved normally. As the errors cannot be canceled by turning the power off andthen on again, please contact your dealer or local JVC-authorized service agent in order to restore normal operation.How to restart10-3. How to cancel the Errors “20”, “21” and “64”1. Turn off the Power.2. Open the door, remove the side and center panels.3. Remove the disc or tray from inside the carrier.4. Replace the panels and close the door. Then turn onthe power while holding down the “0” key on the controlpanel.CAUTIONFirst remove the jammed tray or media, otherwise the media may be damaged during subsequent operations.Downloaded From DvDPlayer-Manual.com JVC Manuals