JVC MC-8200LU Instructions Manual

Also see for MC-8200LU: Instructions Instructions Instructions Service manual

Contents

E13ENGLISH3-4. Removing the optional carrier transport lock screwSetupWhen the MC-CF10U is installed, its special transport lock should be removed in addition to its being unlocked asdetailed in "3-2. Opening the transport lock" on page E11. Use the following procedure when unlocking the optionalcarrier transport lock.1. Remove the transpor t lockscrew (for optional carrier).2. Insert the removed screw into the desigated storage hole forthe transport lock screw.• If the system is transported with the MC-CF10U Optional Carrier installed, refer to "3-2. Opening the transport lock",execute the packing mode and clamp the above-mentioned transport lock screw.3-5. Installing drives and settings SCSI-ID No., etc.1. Installing drivesInstall the drives (a See "7. DRIVE UNITS" on page E22).2. Initial setting of SCSI-ID No., etc.The default setting of the SCSI-ID No. of the MC-8200LU/8600LU is "0".Set the SCSI-ID No. according to your system.• To change the SCSI-ID No. of the MC-8200LU/8600LU a Read "8. SETTING THE SCSI-ID NUMBERS OF THE MAINUNIT" on page E26.• To set the SCSI-ID Nos. and termination of drives a Read the instruction manuals of the installed drives.• As the MC-8200LU/8600LU should be turned on to allow its SCSI-ID No. to be set, read "3-6. Connecting the powercord and cables" on page E14 and connect the power cord before proceeding.Downloaded From DvDPlayer-Manual.com JVC Manuals