JVC LVT1007-010A[A] Instructions Manual

Also see for RX-7032VSL: Instructions Instructions Instructions Instructions Instruction manual

Contents

44VCRYou can always perform the following operations:VCR : Turn on or off a VCR.After pressing VCR (or VCR CONTROL), you can perform thefollowing operations on a VCR:1 – 9, 0: Select the TV channels on a VCR.3: Start playing.REW: Rewind a tape.FF: Fast wind a tape.7: Stop playing or recording.8: Pause playing. To resume, press 3.REC PAUSE: Enter recording pause by pressing this button.To start recording again, press this button then 3.CH +/–: Change the TV channels on the VCR.Note:You can use either the VCR or the VCR CONTROL button to activatethe buttons listed above. If you press the VCR button, the playingsource also changes. On the other hand, pressing the VCRCONTROL button does not change the playing source.Operating Video ComponentsIMPORTANT:To operate JVC’s video components using the supplied remotecontrol:• You need to connect JVC’s video components through the AVCOMPU LINK jacks (see page 39) in addition to the connectionsusing cables with RCA pin plugs (see pages 11 and 12).• Some JVC’s VCRs can accept two types of the control signals—remote code “A” and “B.” Before using this remote control, makesure that the remote control code of the target VCR is set to code“A.”• When using the remote control, aim the remote control directly atthe remote sensor on each component, not on the receiver.2 34 5 68MENUENTERDVD playerAfter pressing DVD or DVD MULTI, you can perform the followingoperations on a DVD player:3: Start playing.4: Return to the beginning of the current (or previous) chapter.¢: Skip to the beginning of the next chapter.7: Stop playing.8: Pause playing. To resume, press 3.After pressing DVD or DVD MULTI,these buttons can be used for the DVDmenu operations.Note:For detailed menu operations, refer to theinstructions supplied with the discs or theDVD player.TVYou can always perform the following operations:TV : Turn on or off the TV.TV VOL +/–: Adjust the volume.TV/VIDEO: Set the input mode (either TV or VIDEO).After pressing TV/DBS, you can perform the following operationson a TV:CH +/–: Change the channels.1 – 9, 0, 100+: Select the channels.RETURN: Alternate between the previously selected channeland the current channel.