(No.MA051)1-153.2.7 Removing the pickup unit(See Figs.14 to 18)• Prior to performing the following procedure, remove the topcover, connector board and chassis unit.(1) Remove the screw D and pull out the pu. shaft holder fromthe pu. shaft.(2) Remove the screw E attaching the feed sw. holder.(3) Move the part e of the pickup unit upward with the pu. shaftand the feed sw. holder, then release the joint f of the feedsw. holder in the direction of the arrow. The joint g of thepickup unit and the feed rack is released, and the feed sw.holder comes off.(4) Remove the pu. shaft from the pickup unit.(5) Remove the screw F attaching the feed rack to the pickupunit.3.2.8 Reattaching the pickup unit(See Figs.14 to 17)(1) Reattach the feed rack to the pickup unit using the screw F.(2) Reattach the feed sw. holder to the feed rack while settingthe joint g to the slot of the feed rack and setting the part fof the feed rack to the switch of the feed sw. holder correct-ly.(3) As the feed sw. holder is temporarily attached to the pickupunit, set to the gear of the joint g and to the bending part ofthe chassis (joint h) at a time.CAUTION:Make sure that the part i on the underside of the feedrack is certainly inserted to the slot j of the change locklever.(4) Reattach the feed sw. holder using the screw E.(5) Reattach the pu. shaft to the pickup unit. Reattach the pu.shaft holder to the pu. shaft using the screw D.Fig.14Fig.15Fig.16Fig.17Fig.18Feed sw. holderEDJoint gJoint fPart ePickup unitPu. shaft holderPu. shaftFeed sw. holderPart ePickup unitFeed rackFeed sw.holderDEJoint fPu. shaftholderPu. shaftPickup unitJoint hPart iSlot jJoint gF Feed rackPickup unitJoint fJoint gFeed rackPickup unitFeed sw. holderwww . xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299http://www.xiaoyu163.comhttp://www.xiaoyu163.com