Warnings by Lamp and Warning ToneWarning status is indicated by tally lamp andwarning tone.0 The tally lamp blinks.0 The warning tone is output from the monitorspeaker or [x] terminal.Memo :0 If you continue to use the camera recorder whilethe power warning is displayed, the camerarecorder will stop automatically when the batteryor supplied voltage from the AC adapterbecomes lower.Caution :0 The remaining battery power and time aredisplayed as they are from the batteryinformation. Accurate data may not be displayeddepending on the battery condition. Replace thebattery as soon as possible when the remainingbattery power and time are low.Turning On/Off the PowerTurning On the Power1 Hold down the lock button (blue) at thecenter of the [POWER ON/OFF(CHG)] switchto set to “ON”.The camera recorder starts up in Camera modeand is ready for shooting.Memo :0 The camera recorder always start up in Cameramode when the [POWER ON/OFF(CHG)]switch is set to “ON”. Use the [MODE] button atthe side of the camera recorder to switch mode.(A P18 [Operation Modes] ).MODEPOWERONOFF(CHG)Turning Off the PowerSets the camera recorder to the recording standbyor stop mode.1 Hold down the lock button (blue) at thecenter of the [POWER ON/OFF(CHG)] switchto set to “OFF(CHG)”.2 Remove the battery and the power to the[DC] terminal (when not in use for a longtime).Auto Power Off functionWhen [System] B [Auto Power Off] is set to “On”,the power turns off automatically when the camerarecorder is not operated for 5 minutes or longerwhile running on battery.(A P110 [ Auto Power Off ] )Memo :0 When both the battery and AC adapter areconnected, power from the AC adapterconnection will be used. As such, the [AutoPower Off] function will not have any effect.Caution :0 Do not set the [POWER ON/OFF(CHG)] switchto “OFF(CHG)” during recording. Check that theoperation mode display is “STBY” or “STOP”before you turn off the power.0 If you have mistakenly set the [POWER ON/OFF(CHG)] switch to “OFF(CHG)” duringrecording, wait for 5 seconds or more before youturn on the power again.0 When turning off the power, first set the[POWER ON/OFF(CHG)] switch of the camerarecorder to “OFF(CHG)”. Do not remove thebattery or turn off the AC power while the[POWER ON/OFF(CHG)] switch is set to “ON”.31Preparations
