23PreparationConnecting to a computer directly(Wi-Fi Direct)Using the WPS function1 Press and hold the power button to power off.2 Disconnect the LAN cable that connects thecamera to your computer.3 Set the network mode switch to "DIRECT".4 Press and hold the power button to power on.The record button starts blinking. Wait until it stopsblinking and off.5 Establish a WPS connection on the computer.For connection, refer to the instruction manual of thedevice.6 Press and hold the "WPS" button.When the "WPS" button stops blinking and stays lit,the connection is complete.If no connection cannot be established within twominutes, the "WPS" button turns off. Try again, or setup manually.Connecting manually1 Press and hold the power button to power off.2 Disconnect the LAN cable that connects thecamera to your computer.3 Set the network mode switch to "DIRECT".4 Press and hold the power button to power on.The record button starts blinking. Wait until it stopsblinking and off.5 Connect to DIRECT-**JVCCAM via wireless LANof the computer.• For connection, refer to the instruction manual ofthe device.• The password is "password" at the time ofpurchase.
