JVC GR-DVL500 Instructions Manual

Also see for GR-DVL300: Instructions Instructions Instructions Instructions Instructions

46 EN12345678– –TTIOMT–EAI–LN:C–O–D~~~~~~~~EO–0U–0T:: –0–0MODEPLAYR.A.EDITON/OFFEFFECTFADE/WIPEEDIT IN/OUTCANCELSELECT SCENES4 Point the remote control at the camcorder’s remotesensor. Press PLAY (4) and then press R.A.EDIT ON/OFF on the remote control.The Random Assemble Editing Menu appears.5 If using a Fade/Wipe at the beginning of the scene,press FADE/WIPE on the remote control.•Cycle through the effects by pressing repeatedly,and stop when the one you want is displayed.•You cannot use a Picture Wipe/Dissolve at thebeginning of Program 1.6 At the beginning of the scene, press EDIT IN/OUT onthe remote control. The Edit-In position appears inthe Random Assemble Editing Menu.7 At the end of the scene, press EDIT IN/OUT. TheEdit-Out position appears in the Random AssembleEditing Menu.8 If using a Fade/Wipe at the end of the scene, pressFADE/WIPE.•Cycle through the effects by pressing repeatedly,and stop when the one you want is displayed.•If you select a Fade/Wipe effect for an Edit-Outpoint, the effect is automatically applied to thefollowing Edit-In point.•You cannot use a Picture Wipe/Dissolve at the endof the last scene.•When you use Fade/Wipe effects, that time isincluded in the total time (this does not apply toPicture Wipe/Dissolve).19 If using Playback Special Effects, press EFFECT( pg. 43).10 Repeat steps 6 through 9 to register additional scenes.•To change previously registered points, pressCANCEL on the remote control. The registeredpoints disappear, one at a time, from the mostrecently registered point.•If you are not using Fade/Wipe or Program AE withspecial effects, repeat steps 6 and 7 only.USING THE REMOTE CONTROL UNIT (cont.)NOTES:●When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference betweenthem.●If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will becanceled and editing will not take place.●If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included inthe edited version.●Since time codes register time only as accurately as seconds, the time code total time may not match thetotal program time exactly.●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.●If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve orBlack & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the nextEdit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone duringrecording, then use the Dissolve or Black & White Fader during Random Assemble Editing.●It is not possible to use Fade/Wipe effects and Program AE with special effects during Random AssembleEditing using a DV cable.Random AssembleEditing MenuProgramRemote sensor