Open the terminal cover (SD card cover)A Open the LCD monitor.B Slide down the terminal coverlock and slide the cover asideC Lift the cover slowly.o To close .Not properly closed if the red mark is visible!Leave the LCD monitor open first.A Flip down the cover slowly while making sure the gray waterproof seal fits intothe opening at the terminals.B Press the entire cover against the camcorder with equal force and firmly attachthe cover completely.C Slide the cover until it clicks into place.(The cover is not properly closed if the red mark at the terminal cover lock isvisible.)CAUTION0 Do not apply excessive force when opening or closing the terminal cover.0 Do not open or close the terminal cover with wet or dirt/sand-covered hands.0 Do not allow any dirt, lint, hair, sand, and other foreign substances toaccumulate between the waterproof seal and the case.0 Never damage or scratch the waterproof seal and terminal cover. Doing socan result in leaks. If the seal is damaged, contact your nearest JVC ServiceCenter for a replacement. (Charges apply.)0 Read the “Detailed User Guide” carefully before using the camcorder underwater or in places exposed to water droplet.(Rear)EN 9