JVC DR-MV1B Instructions Manual

Also see for DR-MV1B: Instructions

Contents

Masterpage:Right+EN 83Filename [DR-MV1SEK_10Subsidiary.fm]Page 83 April 15, 2004 3:21 pmSUBSIDIARY SETTINGSGuide Program Number Set1 Press SET UP to access the Main Menu screen.2 Press w e to select “INITIAL SET UP”, then press ENTER.3 Press w e to select “SAT/GUIDE PR”, then press ENTER.4 Press rt to select “GUIDEPROGRAMME”, then pressENTER.5 Press rt to select the GuideProgram number for the desiredstation as shown in the TV listings.Then press ENTER.● To change the Guide Program number in 10 increments, press andhold rt.6 Press rt to select “TV PROGRAMME”, then press ENTER.7 Press rt to select the number of the unit’s channel position onwhich the Guide Program number’s broadcast is received by theunit or the satellite receiver. Then press ENTER.● Pressing AUX changes “TV PROGRAMME” to “SAT”.● To timer-record a satellite programme with the VIDEO Plus+ system,you need to install a provided Satellite Controller and perform theprocedure described in “Satellite Receiver Control Setting (DVD DeckOnly)” ( pg. 23).● Repeat steps 4 and 7 as necessary.8 Press SET UP to complete the setting.Guide Program Number“Guide Program (GUIDE PROGRAMME) number” refers to theassigned TV station numbers, according to broadcast area, for theVIDEO Plus+ timer recording. The Guide Program numbers can befound in most TV listings.Your unit needs to memorise all necessary stations in channelpositions in order to record TV programmes. Auto Channel Setautomatically assigns all receivable stations in your area to callthem up by using the PR +/– buttons without going through anyvacant channels.Auto Channel Set1 Press SET UP to access the Main Menu screen.2 Press w e to select “INITIAL SET UP”, then press ENTER.3 Press w e to select “AUTO CH SET”, then press ENTER.● When you have connected the unitto a TV offering T-V Link via afully-wired 21-pin SCART cable( pg. 20), the unit automaticallyperforms the Preset Downloadand the T-V LINK screen willappear. ( pg. 20)● The Auto Set screen appears, andremains on screen while the unitsearches for receivable stations.Wait until the TV screen as shown in step 4 appears.VIDEO Plus+ ®System SetupIMPORTANT:Normally, Auto Set Up ( pg. 19), Preset Download ( pg. 20) orAuto Channel Set ( pg. 83) sets the Guide Program numbersautomatically. You need to set the Guide Program numbers manuallyonly in the following cases.● When timer-programming with the VIDEO Plus+ system, thechannel position, where the station you wish to record is receivedon your unit, is not selected,ORwhen you add a channel after Auto Set Up, Preset Download or AutoChannel Set has taken place,—Set the Guide Program number for that station manually.● When you wish to timer-record a satellite programme with theVIDEO Plus+ system,—Set the Guide Program numbers for all satellite broadcasts receivedon your satellite receiver.● Turn on the unit.● Turn on the TV and select the AV mode.● Slide the TV/CABLE/SAT/DVD switch to DVD.Tuner Set● Turn on the unit.● Turn on the TV and select the AV mode.● Slide the TV/CABLE/SAT/DVD switch to DVD.IMPORTANT:Perform the following steps only if —— Auto Channel Set has not been set correctly by Auto Set Upor by Preset Download. ( pg. 19, 20)— you have moved to a different area or if a new station startsbroadcasting in your area.1472580369ENTERSET UPrtw eVCR/DVD SATDR-MV1SEK_00.book Page 83 Thursday, April 15, 2004 3:30 PM