JVC DR-MV1B Instructions Manual

Also see for DR-MV1B: Instructions

Contents

Masterpage:Right+EN 39Filename [DR-MV1SEK_05DVD Operation1.fm]Page 39 April 15, 2004 11:41 amOPERATIONS ON DVD DECKSetting The Progressive ModeYou can obtain optimal picture quality by selecting whether thecontent on the disc is processed by field (video source) or by frame(film source).1 Press ON SCREEN twice to access the on-screen bar.2 Press w e to select “ ”, then press ENTER. The pop-upwindow appears under the selected item.3 Press rt to select the desired option, then press ENTER.AUTO 1: Used to play a disc containing both video and film sourcematerials. This system recognises the source type (video or film)of the current disc according to the disc information. Normallyselect this option.AUTO 2: Almost the same as the “AUTO 1”, but the processing ofthe scenes with movement is different. Select “AUTO 1” or“AUTO 2” to your preference.FILM: Suitable for playing back a progressive scanned film sourcedisc.VIDEO: Suitable for playing back a video source disc. The outlineson the played back pictures will be soft.To clear the on-screen barPress ON SCREEN.NOTE:When the progressive mode is set, be sure to set “L-1 OUTPUT” to“COMPONENT”. ( pg. 74) Progressive scan is output only fromCOMPONENT VIDEO OUT connector.Programme PlaybackYou can play back up to 30 tracks in the desired order.While stopped1 Press ON SCREEN twice to access the on-screen bar.2 Press w e to select “PRGM”, then press ENTER. Theprogramme table appears under on-screen bar.3 Press the number keys toenter the track numbers in thedesired order.Examples:A To select track 5, press thenumber key “5” and ENTER.B To select track 15, press thenumber key “1” and “5”.C To select track 25, press the number key “2” and “5”.If you have specified a wrong selectionPress CANCEL (&). The last selection is erased.Or press CLEAR (8). The whole selection is erased.4 Press 4. Playback starts in the programmed order.● When all of the programmed tracks have been played back,Programme Playback stops, but the programmed informationremains.● To add tracks to the end of the programme, perform steps 1 through3.● During Programme Playback, pressing 6 skips to the nextselection of the programme. Pressing 2 returns to the beginning ofthe current selection.To clear the on-screen bar and the contents of the programmePress ON SCREEN.To cancel Programme PlaybackPress w e to select “PRGM”, then press ENTER.NOTE:Programme Playback is not possible depending on the type of disc.DR-MV1SEK_00.book Page 39 Thursday, April 15, 2004 3:30 PM