JVC DR-MV1 Instructions Manual

Also see for DR-MV1S: Instructions Instructions Bedienungsanleitung

Contents

66 EN EDITINGYou can dub programs from a camcorder or DV equipmentconnected to the unit with a DV cable. The unit’s remote controlallows you the limited control of the connected camcorder or DVequipment functions during dubbing.1 Connect a camcorder or DV equipment to the DV IN connectoron the unit’s front panel.2 Load a DVD-RAM/RW/R disc on the unit.3 Press CH +/– to set the channel to “DV DUBBING”.● The “DV DUBBING” controller appears on the TV screen.● If “ ” does not appear on the “DV DUBBING” controller, makesure the DV equipment is connected correctly.4 Press w e to select , then press ENTER.5 Press rt to select the desiredsound track, then press ENTER.AUDIO 1: Select this to record theoriginal stereo sound playedback on the connected DVequipment.AUDIO 2: Select this to record thedubbed stereo sound playedback on the connected DVequipment.MIX: Select this to record the sound of both “AUDIO 1” and“AUDIO 2”.● Note that this selection is not available when the source program isrecorded in 16BIT (48 kHz) mode.6 Press REC MODE repeatedly to set the recording mode.7 Locate the point from where you want to start dubbing, thenstop or pause playback by pressing the following buttons on theremote control: 4, 5, 3, 8, 9● To play back in slow speed (1/10 of the normal speed), press 9 topause playback, then press 3 or 5.● To play back frame-by-frame, press 9 to pause playback, then press9 repeatedly. Each press of 9 advances a frame.● To change the playback direction, press 3 or 5.8 Press w e to select , then press ENTER. Thedubbing starts.● Playback on the external DV equipment and recording on the unitshould start simultaneously.● When the playback from the beginning is not possible, the “DVDUBBING” controller cannot be used. Perform dubbing without usingthe “DV DUBBING” controller. ( below)● To pause dubbing, press w e to select , then pressENTER. Both the unit and the external DV equipment pause dubbing.Pressing 9 on the unit also works the same way.● To clear the “DV DUBBING” controller from the TV screen, press ONSCREEN.9 Press 8 on the remote control to stop dubbing.● Both the unit and the external DV equipment stop dubbing.NOTES:● Dubbing copyright guarded programs is not possible.● Original DV informations such as the recording date and time are notrecorded.● The superimposed indication during the operation or dubbing is notrecorded.● It is not possible to perform dubbing when “VCR]” lights up on theunit. Press VCR] so that “VCR]” lights off.Performing dubbing without using the “DV DUBBING”controllerA Press CH +/– to set the channel to “DV DUBBING”.B Press REC MODE repeatedly to set the recording mode.C Start playback on the external DV equipment slightly before theactual point from where you wish to start dubbing.D Press 7 on the unit to start recording. Or press and hold 7 andpress 4 on the remote control. The dubbing starts.E When the dubbing ends, press 8 on the unit, then stopplayback on the external DV equipment.DV Dubbing (DVD Deck Only)NOTE:When you connect a PC to the DV IN connector, we do not assurethe normal operation of this unit.F-1DV IN connectorDV cable(VC-VDV 204U)(not supplied)CamcorderDV connectorYour unitDV equipment