JVC DR-DX5SEK Instructions Manual

Also see for DR-DX5SEK: Instructions Service manual

Contents

62 EN EDITINGYou can use a camcorder as the source player and your unit as therecording deck. If your camcorder has a DV IN/OUT connector, youcan use the camcorder as the recording deck and your unit (DVdeck only) as the source player.1 Make connections.A If the camcorder has no S-VIDEO output connector:^ connect the camcorder’s AUDIO/VIDEO OUT connectors tothe unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectorson the front panel.● When using a monaural camcorder, connect its AUDIO OUTconnector to the [AUDIO-L] input connector on your unit.B If the camcorder has an S-VIDEO output connector:^ connect the camcorder’s AUDIO OUT and S-VIDEO OUTconnectors to the unit’s [AUDIO] and [S-VIDEO] inputconnectors on the front panel.C If the camcorder has a DV IN/OUT connector:^ connect the camcorder’s DV IN/OUT connector to the unit’s[DV IN/OUT] connector.● When using your unit as the source player, refer to thecamcorder’s instruction manual for the recording procedure.2 Press DV/HDD/DVD SELECT on the unit repeatedly to selectthe recording deck.3 Press PR +/– to select AF-1B or ADVB.● Set AF-1 INPUTB to AVIDEOB for the [VIDEO] input connector, orAS-VIDEOB for the [S-VIDEO] input connector, depending on theconnector being used. (A pg. 65)4 Press REC MODE repeatedly to set the recording mode. ForDV deck, press REC MODE on the remote control to set therecording mode.5 Start playback on the camcorder slightly before the actual pointfrom where you wish to start dubbing.6 Press R on the unit to start recording. Or while holding R, pressI on the remote control. The dubbing starts.7 Press o on the unit, then stop playback on the camcorder.NOTES:● All necessary cables can be obtained from your dealer.● Refer to the camcorder’s instruction manual for operatingprocedure.● The quality of dubbed picture becomes poorer than that of theoriginal.● When you are editing through the [DV IN/OUT] connector, theunit will stop if the player begins playing a blank portion of tape orthe signal is interrupted.● When connecting the unit to a device equipped with a DV inputconnector, be sure to use the optional DV cable (VC-VDV 204U).● To edit through the [DV IN/OUT] connector using the HDD orDVD deck, refer to ADV Dubbing (HDD & DVD Deck Only)B(A pg. 61).Edit From A CamcorderA If the camcorder has no S-VIDEO output connector:RecorderPlayerTo [VIDEO/AUDIO((MONO) L/R)] inputAudio/video cable(not supplied)AUDIO/VIDEO OUTB If the camcorder has an S-VIDEO output connector:To [S-VIDEO]input To [AUDIO] inputS-video cable(not supplied)AUDIO OUTAudio cable(notsupplied)S-VIDEO OUTRecorderPlayerC If the camcorder has a DV IN/OUT connector:To [DV IN]DV cable(VC-VDV 204U)(not supplied)DV connectorPlayer/RecorderRecorder/Player● Slide the TV/CABLE/SAT/DVD switch to DVD.